Seal, Crankshaft Oil, Rear: Removal: Removal

Fig 1: Lower Air Dam/Belly Pan

Courtesy of CHRYSLER GROUP, LLC

1. Disconnect and isolate the negative battery cable.
2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
3. Remove the belly pan. Refer to BELLY PAN, REMOVAL .
4. Drain the engine oil. Refer to OIL, STANDARD PROCEDURE .
   Fig 2: Upper Bell Housing Bolts

   Courtesy of CHRYSLER GROUP, LLC
5. Remove the manual transmission from the vehicle. Refer to REMOVAL .
   Fig 3: Flywheel Dust Covers & Bolts

   Courtesy of CHRYSLER GROUP, LLC
6. Remove the two bolts (1) and the flywheel dust covers (2 and 3).
   Fig 4: Pressure Plate Bolts

   Courtesy of CHRYSLER GROUP, LLC
7. Remove the clutch and flywheel. Refer to FLYWHEEL, REMOVAL .
   Fig 5: Oil Pan Flange Fasteners

   Courtesy of CHRYSLER GROUP, LLC
8. Remove fourteen bolts (1), two nuts and two studs (2) from the flange of the oil pan.
9. Using the four indicated pry points, carefully remove the oil pan and flywheel dust cover.
   Fig 6: Seal Retainer Attaching Screws & Seal Retainer

   Courtesy of CHRYSLER GROUP, LLC
10. Remove the six seal retainer attaching screws (1).
11. Remove and discard the seal retainer (2).
    Fig 7: Oil Pan Sealant Locations

    Courtesy of CHRYSLER GROUP, LLC
12. Remove all residual sealant (1) from the oil pan, engine block and oil pump. Refer to PAN, OIL, CLEANING .