LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2014 >> 500 Pop, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Electronic Control Modules - (Service Information) - 500E) >> Module, A/C And Heater >> Removal >> Removal

Module, A/C And Heater: Removal: Removal

WARNING: This page is about a different car, the 2014 Fiat 500e. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Air inlet housing removed from view for clarity.

Fig 1: Wire Harness Connector, A/C Heater Module, HVAC Housing, Lower Module Retaining Screw
GC0152611Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Remove the glove box. Refer to GLOVE BOX, INSTRUMENT PANEL, REMOVAL .
  3. Disconnect the wire harness connector (4) from the A/C heater module (2), located on the right side of the HVAC housing (5).
    NOTE:

    Use a flexible drive socket to remove the lower module retaining screw (3).

  4. Remove the three screws (1 and 3) that secure the A/C heater module to the housing and remove the module.
scientia non olet · About LEMON Manuals