Assembly, Gearbox: Installation: Installation
WARNING: This page is about a different car, the 2014 Fiat 500e. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
When performing any repairs that involve contact with high voltage components or systems, the technician performing repairs on the vehicle must verify that the system remains powered down during high voltage repairs.
- This must be done by removing the service disconnect.
- The high voltage check out procedure must also be performed to ensure that the vehicle is properly powered down.
- The technician must know the whereabouts of the service disconnect throughout the repair.
- The technician must ensure that no one reconnects the service disconnect while service is being performed.
- The technician must recheck that the service disconnect has not been reinstalled in cases where the vehicle was unattended.
- Install a new O-ring seal on the electric motor assembly.
- Carefully fit the electric motor (2) to the gearbox assembly.
- Install and tighten the six motor-to-gearbox assembly bolts (1) to 20 N.m (15 ft. lbs.).
- If the vent was removed from the gearbox during the removal procedure, install the vent (3).
- Install the electric drive unit (EDU). Refer to UNIT, ELECTRONIC DRIVE, INSTALLATION .