LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2013 >> 500 Turbo >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> 1.4L 16V Turbo (Service Information) >> Cylinder Head >> Valves, Intake And Exhaust >> Removal >> Removal

Valves, Intake And Exhaust: Removal: Removal

Fig 1: Valve Spring & Retainer
GC0152622Courtesy of CHRYSLER GROUP, LLC
  1. Remove the cylinder head. Refer to CYLINDER HEAD, REMOVAL  .
    NOTE:

    If the springs are to be reused, identify their positions so that they can be reassembled into their original locations. Number 2 cylinder exhaust valve spring shown in illustration, all other valve springs similar.

  2. Remove the valve spring(s) (2). Refer to SPRING(S), VALVE, REMOVAL  .
    Fig 2: Inspecting Valve Margin
    GC0144259Courtesy of CHRYSLER GROUP, LLC
    CAUTION:

    Before removing the valves, remove any burrs from the valve stem retainer lock grooves (2) and stem tip (1) to prevent damage to the valve guides.

  3. Remove the valve(s). Identify each valve to ensure installation in the original location.
    Fig 3: Garter Spring, Valve Guide Seal & Spring Seat
    GC0152627Courtesy of CHRYSLER GROUP, LLC
  4. If required, remove the valve guide seal (2) and spring seat (3). Refer to SEAL(S), VALVE GUIDE, REMOVAL  .
scientia non olet · About LEMON Manuals