Stationary Glass: Windshield: Removal: Removal
- Before proceeding with the following repair procedure, review all warnings and cautions. Refer to STATIONARY GLASS, WARNING .
- Remove the rear view mirror. Refer to MIRROR, REARVIEW, REMOVAL .
- Disconnect the humidity sensor wiring connector, if so equipped.
- Remove the cowl grille. Refer to COVER, COWL PANEL, REMOVAL .CAUTION:
Be careful not to damage painted surfaces when removing moldings or cutting urethane around the windshield.
- Remove molding from the top of the windshield.
- Using an assistant and a wire-type windshield cut-out tool (1, 3 and 4), cut and separate the urethane adhesive (2) securing the windshield to the windshield fence.
- Using appropriate tools, carefully remove the windshield (1) from the vehicle.