Front

ASSEMBLY

NOTE: Passenger seat shown. Driver seat similar.





1. If necessary, install a new Occupant Detection Sensor (ODS) onto the passenger side seat bottom cushion Occupant Detection Sensor - Installation.
2. If necessary, install a new heated seat pad onto the seat bottom cushion Heater Pad - Installation.
3. Position the seat bottom cover (1) onto the seat bottom cushion (3) and attach new hog rings (2).





4. Engage the rear of the seat bottom cover (1) to the seat bottom cushion (2).
5. Install the seat bottom cushion and cover Seat Cushion Cover - Installation.