P16AA

P16AA-CRUISE CONTROL SYSTEM - VEHICLE SPEED TOO HIGH

Theory of Operation

The vehicle operator controls all speed control system features through the speed control switch pod on the face of the right horizontal spoke of the steering wheel. When a push button of the switch pod is depressed, it provides a hard wired resistor multiplexed analog input to the Body Control Module (BCM). The BCM is a gateway to the Controller Area Network (CAN) data bus and not only reads the hard wired speed control switch and stop (brake) lamp switch inputs, but also relays these inputs to the Powertrain Control Module (PCM) over the CAN bus.

- When Monitored:
With the ignition on.

- Set Condition:
The vehicle speed is above 250 kph for 0.5 of a second.





Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Pre-Diagnostic Troubleshooting Procedure.
DTC EXPLANATION

NOTE: This DTC indicates that the vehicle speed has gone above the upper limit of speed control function.

View Repair.

Test Complete.
No repair necessary.