Rear Flexible Hose

Fig 1: Flexible Brake Hose & Fitting

Courtesy of CHRYSLER GROUP, LLC

Position the flexible brake hose (2) near the installed position.
Install the rear brake hose fitting (1) to the caliper and tighten to 16 N.m (142 in. lbs.).

Fig 2: Flexible Hose, Solid Line & Clip
Courtesy of CHRYSLER GROUP, LLC
Position the flexible brake hose (1) through the bracket and install the retaining clip (2).
Install the solid brake line fitting (3) and tighten to 16 N.m (142 in. lbs.).
Install the tire and wheel assembly. Refer to INSTALLATION .
Lower the vehicle.
Remove the prop rod from the brake pedal.
Bleed the area of repair for the brake system. If a proper pedal is not felt during bleeding an area of repair then a base bleed system must be performed . Refer to STANDARD PROCEDURE . .