Passenger Seat

Fig 1: Trim Cap & Seat Back Recliner Lever

Courtesy of CHRYSLER GROUP, LLC

NOTE:

Before proceeding with the following procedure, review all Warnings and Cautions. Refer to SEATS, WARNING .

Using (special tool #C-4755, Trim Stick), remove the trim cap (1) from the seat back recliner lever (2).

Fig 2: Screw, Seat Back Recliner Lever, Inboard Seat Cushion Side Shield & Washer
Courtesy of CHRYSLER GROUP, LLC
Remove the screw (1) and washer (2) that secure the seat back recliner lever (3) to the seat and remove the lever.
Remove the two screws that secure the inboard seat cushion side shield (4) to the seat and remove the side shield.

Fig 3: Lift The Fabric
Courtesy of CHRYSLER GROUP, LLC
Lift the fabric (1) covering the recliner cable.

Fig 4: Tie Strap & Cable Retaining Clip
Courtesy of CHRYSLER GROUP, LLC
Install a tie strap (2) through the hole of the seat recliner lever that secures the cable retaining clip (1). Cut off the excess length from the tie strap.
Attach the cable retaining clip (1) to the seat adjusting lever if disengagement has occurred.
NOTE:
Make sure the head of the tie strap is facing outward and does not interfere with lever travel.

Fig 5: Screw, Seat Back Recliner Lever, Inboard Seat Cushion Side Shield & Washer
Courtesy of CHRYSLER GROUP, LLC
Position the inboard seat cushion side shield (4) to the seat and install the two retaining screws. Tighten the screws securely.
Install the seat back recliner lever (3).
Install the screw (1) and washer (2) that secures the seat back recliner lever. Tighten the screw securely.

Fig 6: Trim Cap & Seat Back Recliner Lever
Courtesy of CHRYSLER GROUP, LLC
Install the trim cap (1) onto the seat back recliner lever (2).
Install the front seat. Refer to SEAT, FRONT, INSTALLATION .