Molding, Body Side: Removal: Removal

Fig 1: Body Side Molding

Courtesy of CHRYSLER GROUP, LLC

As a guide for installation, apply a length of masking tape on the bodyside, parallel to the top edge and, to one end of each body side molding (1 and 2) being removed
CAUTION:
Do not exceed 32° C (90° F) when heating the cladding or body panels. Failure to follow this caution may result in damage to the cladding and/or the vehicle paint finish.
If the temperature is below 21° C (70° F), warm the body side moldings with a heat lamp or heat gun.
NOTE:
The body side moldings are attached with an adhesive tape.
Using a trim stick (special tool #C-4755, Trim Stick), carefully remove the moldings (1 and 2) from the bodyside.