With Automatic Transmission

WITH AUTOMATIC TRANSMISSION





1. Remove the engine and transmission from the vehicle Engine - Removal.





2. Remove the starter assembly (5) Starter - Removal.





3. Remove the transmission and flexplate (1) from the engine Flexplate - Removal





4. Remove three bolts (3 and 4), one bolt and nut (2) and the transmission adapter plate (1).





5. Drain the engine oil Service and Repair.
6. Remove the viscosity sensor (2) Oil Viscosity Sensor - Removal.





7. Remove two bolts (2) and the blocker plate (1) from the oil pan.





8. Remove fourteen bolts (1), two nuts and two studs (2) from the flange of the oil pan.
9. Using the four indicated pry points, carefully remove the oil pan.





10. Remove the six seal retainer attaching screws (1).
11. Remove and discard the seal retainer (2).





12. Remove all residual sealant (1) from the oil pan, engine block and oil pump Procedures.