Power Brake Booster: Removal
- Remove both wiper arm assemblies. Remove cowl panel cover to expose windshield wiper module. Remove windshield wiper module-to-body bolts. Remove windshield wiper module.
- Remove nuts and carefully slide master cylinder from power brake booster with brakelines attached and allow assembly to rest against left shock tower.
- Disconnect vacuum hoses from check valve on power brake booster. DO NOT remove check valve from power brake booster.
- Remove power brake booster rod-to-brake pedal pin retaining clip by positioning small screwdriver between center tang on retaining clip. Rotate screwdriver enough to allow retaining clip center tang to pass over end of brake pedal pin. Pull retaining clip from brake pedal pin. Discard pedal pin retaining clip. Disconnect brake booster rod from brake pedal pin.
- Remove power brake booster-to-dash panel nuts located below the dash panel, near steering column and brake pedal bracket. Slide brake booster upward and to right of dash panel, as mounting holes are slotted on dash panel. Tilt power brake booster outward and then upward and remove.
CAUTION:
DO NOT attempt to disassemble power brake booster. Power brake booster is serviced ONLY as a complete unit.