LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1997 >> Vision ESi, 3.5 F >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Disc Brakes & Drum Brakes >> Bleeding Brake System >> Bleeding Procedure >> Pressure Bleeding

Pressure Bleeding

  1. Connect pressure bleeder to master cylinder using appropriate adapters. Install clear hose on right rear bleed screw. Place other end of hose in clean, transparent container of brake fluid.
  2. Open valve on pressure bleeder. Open bleed screw at least one full turn. When brake fluid flow is clear and free of bubbles, close bleed screw.
  3. Bleed remaining brakelines in proper sequence at each wheel. See BRAKELINE BLEEDING SEQUENCE  table. Ensure bleed screws are tightened to specification. See TORQUE SPECIFICATIONS  .
  4. Close valve on pressure bleeder. Remove pressure bleeder from master cylinder. Fill master cylinder with brake fluid (if necessary). Install cap on master cylinder.
scientia non olet · About LEMON Manuals