Driver-Side Air Bag Module & CLOCKSPRING: Removal
WARNING: This page is about a different car, the 1995 Mitsubishi Mirage and 1995 Eagle Summit. However, it is still accessible from the selected car via links, so may be relevant.
- Before proceeding, follow air bag service precautions. See SERVICE PRECAUTIONS. Turn ignition switch to LOCK position. Disconnect negative battery cable. Shield cable end. Wait at least 60 seconds before servicing.
- Ensure front wheels are in straight-ahead position and steering wheel is locked. Remove covers from sides of air bag module for access to screws. See Figure . Remove air bag module screws.
- Lift air bag module for access to clockspring connector at air bag module. To disconnect clockspring connector from air bag module, spread connector open and pry it outward with a screwdriver. Remove air bag module.
- Place air bag module on flat surface with trim cover facing up. Disconnect electrical connectors from steering wheel. Remove steering wheel using a steering wheel puller. Remove column cover(s). Disconnect clockspring lower connectors. Remove clockspring mounting screws. Remove clockspring.
WARNING:
If front wheels are not in straight-ahead position or clockspring mating marks are not aligned before installing steering wheel, the steering wheel may not turn completely, or flat cable inside clockspring may be severed, disabling SRS system and possibly causing serious injury to driver.