LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1996 >> Summit ES, 1.8 C >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Air Bag Restraint System) >> Diagnosis & Testing >> Scan Tool Can Communicate With Other Systems >> SRS Warning Light Does Not Come On

SRS Warning Light Does Not Come On

WARNING: This page is about a different car, the 1995 Mitsubishi Mirage and 1995 Eagle Summit. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, follow air bag service precautions. See SERVICE PRECAUTIONS. Turn ignition switch to LOCK position. Disconnect negative battery cable. Shield cable end. Wait at least 60 seconds before servicing. Remove floor console assembly.
  2. SDUs use two distinct types of connector locks. See Figure and Figure .
  3. Connect SDU Red 14-pin connector to SRS check harness connector No. 3. See Fig 1 . See SPECIAL TOOLS. At SRS check harness connector No. 5, check for continuity between ground and terminals No. 19 and 20. See Fig 1 . If there is no continuity, replace harness between SDU and ground.
    Fig 1: Identifying SRS Check Harness Connectors
    G95H26077Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. If there is continuity, measure voltage between ground and terminals No. 11 and 12. If no voltage is present, verify fuses are not blown. (Fuses 2, 7 and multi-purpose fuse 3). If less than 9 volts is present at either or both terminals, replace harness between SDU and ignition switch. If 9 volts or more is present at both terminals, check for faulty harness between SDU and DLC. If harness is okay, replace SDU.
scientia non olet · About LEMON Manuals