Park/Neutral Position (PNP) Switch
- Place gear selector lever and manual control lever on transaxle in Neutral position. Loosen park/neutral position switch retaining screws. Rotate park/neutral position switch body so hole in manual control lever aligns with hole on park/neutral position switch body. See Fig 1
. Tighten park/neutral position switch retaining screws to specification. See TORQUE SPECIFICATIONS
.
- Loosen shift control cable lock nut at shift control cable-to-manual control lever. Pull end of shift control cable toward manual control lever. Tighten shift control cable lock nut to specification. See TORQUE SPECIFICATIONS
.
- Move gear selector lever through all gear ranges. Ensure manual control lever is in gear position corresponding to gear selector lever. Ensure vehicle starts only in Park and Neutral.
Courtesy of CHRYSLER CORP.