Wheel Bearing
- Raise and support vehicle. Remove rear wheel assembly. Remove brake disc or drum if necessary. Measure axle shaft end play using dial indicator. See AXIAL END PLAY & ROTARY SLIDING RESISTANCE SPECIFICATIONS table.
- If end play exceeds limit, retighten wheel bearing nut or companion flange nut (if equipped) to specification. See TORQUE SPECIFICATIONS . DO NOT back off wheel bearing nut more than 15 degrees to align cotter pin holes (if equipped). Recheck end play. If end play exceeds limit, replace wheel bearings.
- Check rotary sliding resistance. Attach a spring scale to hub bolt. Measure rotary sliding resistance by pulling spring scale at a90-degree angle to hub bolt. Note measurement when hub begins to rotate. See AXIAL END PLAY & ROTARY SLIDING RESISTANCE SPECIFICATIONS table. If resistance exceeds limit, remove and inspect wheel bearings. Replace wheel bearings as needed.
AXIAL END PLAY & ROTARY SLIDING RESISTANCE SPECIFICATIONS
| Application | End Play In. (mm) | Rotary Resistance Lbs. (kg) |
|---|---|---|
| Mirage & Summit | .008 (.20) | 4.9 (2.2) |