LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1996 >> Summit ES, 1.8 C >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> Compressor Servicing >> SANDEN Scroll >> Clutch Coil & Shaft Seal >> Removal

Clutch Coil & Shaft Seal: Removal

  1. Remove drive belt pulley (if equipped). Hold clutch plate using Pliers (MB991367) and Bolts (MB991386). Use a ratchet and socket to remove clutch hub nut.
  2. Remove clutch plate. See Figure . Remove snap ring with internal snap ring pliers. Remove clutch hub (rotor). Remove snap ring and clutch coil.
  3. Using an awl, remove bearing cover and retainer. Using Bearing Remover (MB991456), engage bearing grooves. Place base of bearing remover over remover arms and tighten nut.
  4. Tighten bearing remover bolt to withdraw bearing from compressor. Engage grooves of Shaft Seal Remover/Installer (MB991458) and pull straight up on shaft seal.
scientia non olet · About LEMON Manuals