LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1995 >> Talon ESi, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (2.5L V6 Engine - VIN [N] - Avenger & SEBRING Coupe) >> Adjustments >> Accelerator Cable >> Without Cruise Control

Without Cruise Control

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1997 Dodge Avenger, 1997 Chrysler Sebring, 1996 Dodge Avenger, 1996 Chrysler Sebring, and 1995 Dodge Avenger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn all accessories off. Start engine and allow it to reach normal operating temperature. Ensure engine RPM is correct. Turn ignition off. Check accelerator cable for sharp bends. Check for excessive free play or absence of free play at accelerator cable. Accelerator cable free play should be .04-.08" (1-2 mm). If either condition exists adjust cable.
  2. To adjust accelerator cable, turn ignition on for about 15 seconds. This will allow Idle Air Control (IAC) motor to initialize. Loosen accelerator cable adjusting bolts. See Fig 1. Slide accelerator cable plate away from throttle body until throttle lever starts to move.
  3. Move accelerator cable plate back toward throttle body .04-.08" (1-2 mm) and tighten accelerator cable adjusting bolts to specified torque. See TORQUE SPECIFICATIONS . After adjusting accelerator cable, ensure throttle lever stopper touches fixed SAS. See Fig 2.
Fig 1: Identifying Accelerator Cable Adjusting Bolts
G00078720Courtesy of CHRYSLER CORP.
Fig 2: Identifying Throttle Lever Stopper & Fixed SAS
G00078719Courtesy of CHRYSLER CORP.
scientia non olet · About LEMON Manuals