Rear Brake Caliper, Pads & Rotor: Installation
- Clean caliper piston-to-pad contact area. Seat caliper piston in caliper by rotating piston until seated using Piston Wrench (MB990652). Align caliper piston stopper grooves with projection on pad.
- To install, reverse removal procedure. Tighten caliper guide pin, lock pin and wheel lug nuts to specification. See TORQUE SPECIFICATIONS.
- Pump brake pedal until firm. Bleed brake system. See BLEEDING BRAKE SYSTEM. Check parking brake adjustment. See PARKING/EMERGENCY BRAKE under ADJUSTMENTS.