Stabilizer Bar: Inspection
- Check bushings for wear and deterioration. Check stabilizer bar, stabilizer link and all bolts for damage and wear. Check ball joint dust cover for cracks. Replace components as necessary.
- If replacing ball joint dust cover, remove clip ring and dust cover. Pack new dust cover with grease. Wrap stud threads using vinyl tape, and install dust cover. Secure cover using clip ring.
- Check stabilizer link ball joint starting torque. Deflect ball joint stud from side to side several times. Install 2 nuts on ball joint. Measure ball joint starting torque using INCH-lb. torque wrench.
- Starting torque should be 15-28 INCH lbs. (1.7-3.2 N.m). If starting torque exceeds specification, replace link. If ball joint starting torque is less than specification, ball joint may be reused unless it has drag and excessive play.