Torque Specifications (1.8L)
TORQUE SPECIFICATIONS (1.8L)
| Application |
Ft. Lbs. (N.m) |
| A/C Compressor Mounting Bracket Bolts |
|
| A/C Tensioner Pulley Bolt |
18 (24) |
| Camshaft Sprocket Bolt |
66 (90) |
| Connecting Rod Cap Bolt |
|
| Crankshaft Pulley/Dampener Bolt1 |
136 (185) |
| Cylinder Head Bolt (Cold Engine) |
| Step 1 |
55 (75) |
| Step 2 |
Fully Loosen |
| Step 3 |
14.5 (20) |
| Step 4 |
1/4 turn (90 degrees) |
| Step 5 |
1/4 turn (90 degrees) |
| Engine Support Bracket Bolt |
36-47 (49-64) |
| Exhaust Manifold Nut (Upper) |
11-14 (15-19) |
| Exhaust Manifold Nut (Lower) |
22 (30) |
| Flywheel/Drive Plate Bolt |
72 (100) |
| Intake Manifold Bolt |
14 (19) |
| Main Bearing Cap Bolt |
|
| Oil Drain Pan Bolt |
29 (40) |
| Oil Filter Bracket Bolt |
11-16 (15-22) |
| Oil Pick-Up Tube Bolt |
14 (19) |
| Oil Pump Relief Plug |
33 (45) |
| Oil Pump Case Mounting Bolt |
10 (14) |
| Oil Pump Case Cover Mounting Bolt |
7 (10) |
| Oil Pressure Switch |
7 (10) |
| Oil Seal Case Mounting Bolt |
8 (11) |
| Power Steering Pump Bolts |
33 (45) |
| Oxygen Sensor |
33 (45) |
| Rocker Arm Assembly Bolts |
23 (32) |
| Thermostat Housing Bolts |
14 (19) |
| Throttle Body Bolt |
14 (19) |
| Timing Belt Pulley Tensioner Bolt |
18 (24) |
| Timing Belt Pulley Tensioner Spring Bolt |
33 (45) |
| Water Pump Bolt |
| Except 8 x 65-mm |
10 (14) |
| 8 x 65-mm |
15-19 (20-26) |
| INCH Lbs. (N.m) |
| Bell Housing Cover Bolts To Block |
80 (9) |
| Bell Housing Cover Bolt To Trans |
80 (9) |
| Fuel Rail Bolt |
108 (12) |
| Oil Pan Bolt/Nut |
61 (7) |
| Timing Belt Cover Bolt |
88 (10) |
| Valve Cover Bolt |
34 (4) |