LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1994 >> Summit LX, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.5L 4-CYL - VIN [A] & 1.8L 4-CYL - VIN [C] >> Removal & Installation >> Engine >> Removal

Removal & Installation: Engine: Removal

  1. Release fuel pressure. See FUEL PRESSURE RELEASE  under REMOVAL & INSTALLATION. Remove hood, air cleaner, battery, and battery tray. Drain cooling system. Drain engine oil and transaxle oil. Remove transaxle assembly. See appropriate CLUTCHES article or TRANSMISSION SERVICING article.
  2. Disconnect radiator and heater hoses. Remove radiator. Remove fuel lines, vacuum hoses, and electrical connections from engine.
  3. Disconnect accelerator cable. Remove A/C compressor and power steering pump from engine (if equipped), leaving hoses connected. Wire units aside. Disconnect exhaust pipe at manifold.
  4. Install engine hoist. Raise engine slightly. Remove all engine mount bolts. Remove engine assembly.
CAUTION: Replace axle shaft retainer rings whenever axle shafts are removed from transaxle.
scientia non olet · About LEMON Manuals