LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1994 >> Summit LX, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.5L 4-CYL - VIN [A] & 1.8L 4-CYL - VIN [C] >> Removal & Installation >> Cylinder Head >> Installation

Cylinder Head: Installation

  1. Install cylinder head gasket with identification mark toward timing belt, facing up. See Fig 1. Install cylinder head. DO NOT apply sealant to head gasket. Tighten the bolts to specification in sequence, in 3 steps. Refer to TORQUE SPECIFICATIONS . Refer to Figure.
  2. Install timing belt and camshaft sprocket in original location. Ensure timing marks are aligned. See TIMING BELT . To complete installation, reverse removal procedure. Refill cooling system. Adjust all control cables.
Fig 1: Locating Cylinder Head Gasket Identification Mark (1.5L)
G90D08781Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.


  1. Install cylinder head using new gasket. Ensure identification mark at timing belt end of gasket faces upward. DO NOT apply sealant to head gasket. Install and tighten cylinder head bolts (in 5 steps) to specification in proper sequence. See Figure.
  2. To complete installation, reverse removal procedure. Apply sealant to contact surfaces of semi-circular packing. Apply gasoline to "O" ring on fuel line before installing fuel line in fuel delivery pipe. Adjust all control cables. Fill cooling system.
scientia non olet · About LEMON Manuals