LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1993 >> Talon ES, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.0L 4-CYL - VIN [E] & 2.0L 4-CYL Turbo - VIN [F] >> Removal & Installation >> Engine >> Removal

Removal & Installation: Engine: Removal

  1. Release fuel pressure. See FUEL PRESSURE RELEASE  under REMOVAL & INSTALLATION. Drain cooling system. Remove hood and radiator. Remove transaxle. See appropriate article in the CLUTCHES Section or appropriate TRANS SERVICE Section.
  2. Disconnect necessary control cables, electrical connections, vacuum hoses and coolant hoses. Disconnect fuel lines. Remove power steering pump and A/C compressor with hoses attached, and secure them aside.
  3. Disconnect exhaust pipe at exhaust manifold. Disconnect power steering hose clamp near front mount.
    CAUTION: If removing lower engine mounts from frame, mark position of mount before removing. Mounts must be installed in original locations to provide proper positioning of engine.
  4. Support engine using engine hoist. Remove through bolts from engine mount near timing belt cover and rear engine mounts. DO NOT  remove engine mounts from frame. Remove engine assembly.
scientia non olet · About LEMON Manuals