LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1993 >> Summit ES, 4D Sedan, Automatic >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Suspension - Rear (Fwd) >> Removal & Installation >> Rear Suspension Assembly >> Installation

Rear Suspension Assembly: Installation

  1. If trailing arm bushing needs replacing, remove bushing using Bushing Press (MB991045 ). Remove lateral rod bushing using Driver (MB990947-01 ) and Adapters (MB990847-01 and MB990845-01 ).
  2. Press in new arm bushing from beveled side of housing. Ensure slots in bushing face front-to-rear. Press in new lateral rod bushing using driver. Ensure bushing protrudes equally on both sides.
  3. To complete installation, reverse removal procedure. Bleed brakes, and check wheel bearings. See WHEEL BEARING  under ADJUSTMENTS & INSPECTION. Tighten all fasteners to specification. See TORQUE SPECIFICATIONS  table at end of article. Check wheel alignment.
scientia non olet · About LEMON Manuals