LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1993 >> Summit ES, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Clutches) >> Removal & Installation >> Clutch Master Cylinder >> Removal & Installation (Hydraulic Clutch)

Removal & Installation (Hydraulic Clutch)

WARNING: This page is about a different variant/trim than selected.
  1. Drain master cylinder. Disconnect external reservoir (if equipped). Remove cotter pin, washer and clevis pin. Disconnect push rod from clutch pedal. Remove hydraulic line at clutch master cylinder and plug.
  2. Remove retaining nuts and clutch master cylinder. To install, reverse removal procedure. Apply grease to clevis pin before installation. Bleed clutch system.
scientia non olet · About LEMON Manuals