Clutch Assembly: Installation

WARNING: This page is about a different variant/trim than selected.

Using clutch pilot, install pressure plate and clutch disc. Tighten bolts evenly in a crisscross pattern to specification. See TORQUE SPECIFICATIONS at the end of this article.
Clean release bearing sliding surface. Apply multipurpose grease to release bearing sliding surface. Apply a light amount of grease to input shaft splines. DO NOT allow grease or dirt on clutch disc or pressure plate surfaces.
To install remaining components, reverse removal procedure. Refill all fluids to proper levels. Adjust all control cables, clutch pedal height and free play. See CLUTCH PEDAL HEIGHT & FREE PLAY under ADJUSTMENTS.