LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1993 >> Summit ES, 4D Sedan, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Clutches) >> Removal & Installation >> Clutch Assembly >> Inspection

Clutch Assembly: Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Check release bearing and release fork for damage or wear. DO NOT  clean bearing assembly in solvent. Inspect hydraulic system components for fluid leakage and cylinder dust boot for cracks or deterioration.
  2. Inspect pressure plate surface for wear, cracks, and/or discoloration. Check clutch disc rivets and replace assembly if loose. Measure diaphragm spring ends for wear and uneven height. Replace assembly if height difference between fingers exceeds .02" (.5 mm).
  3. Check facing of clutch disc for loose rivets, uneven contact, deterioration, seizure or oil saturation. Measure distance from clutch disc surface to head of rivet. Replace clutch disc if distance is less than .012" (.30 mm). Replace worn or defective components as necessary.
CAUTION: Install clutch disc with manufacturer's stamp mark (located near hub of clutch disc) toward pressure plate.
scientia non olet · About LEMON Manuals