LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1992 >> Summit ES, 2D Hatchback, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.5L 4-CYL - VINS [A,J,X] & 1.6L 4-CYL - VIN [Y] >> Removal & Installation >> Engine >> Removal (Colt, Colt 200, Mirage & Summit)

Removal (Colt, Colt 200, Mirage & Summit)

  1. Release fuel pressure. See FUEL PRESSURE RELEASE . Remove hood, air cleaner, battery, and battery tray. Drain cooling system. Drain engine oil and transaxle oil. Remove transaxle assembly. See appropriate article in CLUTCHES or TRANSMISSION SERVICING.
  2. Remove radiator and heater hoses. Remove radiator. Remove fuel lines, vacuum hoses, and electrical connections from engine.
  3. Disconnect accelerator cable. Remove A/C compressor and power steering pump from engine (if equipped), leaving hoses connected. Wire units aside. Disconnect exhaust pipe at manifold.
  4. Install engine hoist. Raise engine slightly. Remove all engine mount bolts. Remove engine assembly.
CAUTION: Replace drive axle shaft retainer rings whenever drive axle shafts are removed from transaxle.
scientia non olet · About LEMON Manuals