Removal & Installation: Speedometer: Installation
- Position speedometer and secure with screws. Grasp pointer by hub and gently place bushing onto trip reset shaft. Pointer tip should be indicating approximately 90 MPH (140 KPH).
- Rotate pointer assembly counterclockwise while gently pushing down on hub toward the dial surface (a slight resistance should be felt). Clearance between hub underside and dial surface should be .020-.060" (.50-1.52 mm) before pointer tip is in line with the zero horizontal graduation.
- Stop when pointer tip comes in line with zero horizontal graduation. If pointer tip DOES NOT
align with horizontal graduation, perform either of the 2 following steps:
- If pointer is too high, continue rotating assembly counter- clockwise until alignment is achieved. Repeat procedure if necessary. To install cluster assembly, reverse removal procedure.
- If pointer is too low, rotate pointer assembly clockwise until rotational resistance is felt (this does not refer to contact with trip reset shaft). Continue rotating in direction of resistance to compensate for initial misalignment. Release hub allowing pointer assembly to rotate back to its reset position. Repeat procedure if necessary. To install cluster assembly, reverse removal procedure.