LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1990 >> Talon Base, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.0L 4-CYL - VIN [R] & 2.0L Turbo 4-CYL - VIN [U] >> Removal & Installation >> Engine >> Removal

Removal & Installation: Engine: Removal

  1. Disconnect Black/White wire fuel pump connector at rear side of fuel tank. Start and operate engine until it stops.
  2. Turn ignition off. Disconnect negative battery cable. Reinstall fuel pump connector. Drain cooling system. Remove hood and radiator. Remove transaxle. See appropriate CLUTCHES or AUTOMATIC TRANSMISSION REMOVAL article.
  3. Disconnect necessary control cables, electrical connections, vacuum hoses and coolant hoses. Disconnect fuel lines. Remove power steering pump and A/C compressor with hoses attached, and secure aside.
  4. Disconnect exhaust pipe at exhaust manifold. On 2.0L models, disconnect oil cooler hoses. Disconnect power steering hose clamp near front mount near timing belt cover.
  5. Support engine with engine hoist. Remove through bolt from engine mount, near timing belt cover and rear engine mounts. DO NOT  remove engine mounts from frame. Remove engine assembly.
CAUTION: If lower engine mounts are removed from frame, ensure position of mount is marked prior to removal. Mounts must be installed in original location to provide proper positioning of the engine.
scientia non olet · About LEMON Manuals