LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1990 >> Talon Base, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.0L 4-CYL - VIN [R] & 2.0L Turbo 4-CYL - VIN [U] >> Engine Oiling >> Oil Pump & Front Cover >> Installation

Oil Pump & Front Cover: Installation

  1. Lubricate oil pump gears with engine oil and install with timing marks aligned. See Fig 1 . Install oil pump cover and tighten bolts to specification.
  2. If crankshaft oil seal was removed, use Seal Installer (MD998375) to install seal in front cover. Use a socket of proper diameter to install silent shaft oil seals.
    Fig 1: Oil Pump Gear Timing Marks
    G90E02633Courtesy of CHRYSLER MOTORS.
  3. Position Oil Seal Guide (MD998285) over front of crankshaft. Lubricate crankshaft oil seal and oil seal guide with engine oil. Install front cover with new gasket and temporarily bolts. Install oil filter bracket. Ensure proper length bolts are installed. See Fig 2 .
    Fig 2: Installing Front Cover Bolts
    G90G02634Courtesy of CHRYSLER MOTORS.
  4. To install remaining components, reverse removal procedure. Install plug cap using new "O" ring and tighten to specification. Apply thread sealant to switch threads prior to installation. Tighten all bolts to specification.
scientia non olet · About LEMON Manuals