LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1990 >> Summit DL, Standard >> Repair and Diagnosis (Single Page) >> Transmission >> Manual Trans >> Overhaul - F4M20, F5M20/30 & Km200 4 & 5-Speed >> Component Disassembly & Reassembly >> Clutch Housing >> Disassembly

Clutch Housing: Disassembly

  1. Remove select lever assembly and select lever shoe. Remove interlock plate bolt and gasket. Position control finger so that spring pin will not contact clutch housing. Drive spring pin from control finger using a punch.
  2. Remove spacer, control finger, neutral return spring and interlock plate. Using a 13 mm socket and extension bar, remove needle bearings. Remove control shaft, dust boot, oil seal and needle bearing from clutch housing. See Figure .
scientia non olet · About LEMON Manuals