Installation (Colt, Colt Vista/Colt Wagon 2WD, 200 & Summit)

Using clutch alignment tool, install disc and pressure plate. Tighten bolts evenly in a crisscross pattern to specification. See the appropriate TORQUE SPECIFICATIONS table at end of article.
Clean release bearing sliding surface. Apply multipurpose grease to release bearing sliding surface. Apply a light amount of grease to input shaft splines. DO NOT allow grease or dirt on clutch disc or pressure plate surfaces.
To install remaining components, reverse removal procedure. Refill all hydraulic fluids to proper levels. Adjust all control cables, clutch pedal height and pedal free play. Refer to CLUTCH PEDAL HEIGHT & FREE PLAY under ADJUSTMENTS.

NOTE: For transaxle and clutch service on Colt Vista 4WD, manufacturer recommends removing engine and transaxle as a unit.