Upper & Lower Arms (Colt Wagon 4WD): Installation

If lower arm bushing needs to be replaced, use Bushing Remover/Installer (MB990880), Arbor (MB990886) and Base (MB990891) for front bushing, and Remover/Installer (MB990650), Arbor (MB990885) and base for rear bushing.
On front bushing, install front bushing with larger hollow area of bushing toward rear of vehicle. Install bushing from beveled end of pipe section of lower arm. For all bushings, press fit bushings until bushing protrudes equally on each side of arm.
To complete installation, reverse removal procedure. When installing stabilizer link, hold link with a wrench and tighten nut until distance from end of bolt to edge of nut is .74-.82" (19-21 mm). Tighten all remaining fasteners to specification. See appropriate TORQUE SPECIFICATIONS table at end of article.

NOTE: Coil springs have color marks for spring identification and load classification. When replacing springs, ensure markings are correct for appropriate vehicle.