Colt, Colt Wagon 4WD, Colt 200 & Summit: Removal

Raise and support vehicle. On Colt Wagon 4WD, remove undercover and centermember.
On Colt, Colt 200 and Summit, disconnect tie rod end from steering knuckle. Remove rear roll stopper and bracket mounting bolts. Pull roll stopper forward.
On all models, use 2 wrenches and Allen wrench to remove stabilizer link mounting nuts. Remove stabilizer link, joint cups and bushings (if equipped).
Note location of brackets and bushings. Remove stabilizer bar mounting bolts and brackets. Remove stabilizer bar and bushings. Remove bushings from stabilizer bar.