LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1990 >> Summit DL, Standard >> Repair and Diagnosis (Single Page) >> Suspension >> Front Suspension >> Suspension - Front >> Stabilizer Bar R & I >> Colt Wagon 2WD >> Installation

Colt Wagon 2WD: Installation

  1. To install, reverse removal procedure. Install brackets in original positions. Install bushings securely in brackets.
  2. Tighten stabilizer-to-lower control arm nuts until distance from end of bolt to nut is as specified. See STABILIZER BOLT LENGTH SPECIFICATIONS table.
  3. Tighten remaining stabilizer bolts and nuts to specification with vehicle on ground and suspension unloaded. See TORQUE SPECIFICATIONS table at end of article. Check front end alignment.
STABILIZER BOLT LENGTH SPECIFICATIONS

Application In. (mm)
Colt Vista 4WD .83-.91 (21.1-23.1)
scientia non olet · About LEMON Manuals