LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1990 >> Summit DL, Standard >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Testing >> Rear Axle Hub Bearing (Colt Vista) >> Installation (Colt Vista 4WD)

Installation (Colt Vista 4WD)

  1. Using driver with adapter, install bearing in inner arm. Using seal driver, install oil seal with concave surface facing outward from rear of inner arm. Align marks and install inner arm bolts.
  2. Apply semi-drying sealant to inner arm mating surface. Install backing plate. Install dust cover onto axle shaft with concave side facing bearing. Press bearing onto axle shaft.
  3. Install companion flange and tighten nut to specification. See TORQUE SPECIFICATIONS (COLT VISTA)  table. Ensure end play is .031" (.79 mm) or less. If not, check wheel bearings. Reconnect companion flange to drive axle. Install brake drum.
scientia non olet · About LEMON Manuals