Installation (Colt Vista 4WD & 1990 Colt Wagon 4WD)

Using clutch alignment tool, install disc and pressure plate. Tighten bolts evenly in a crisscross pattern to specification. See appropriate TORQUE SPECIFICATIONS table at end of article.
Clean release bearing sliding surface. Apply multipurpose grease to release bearing sliding surface. Apply a light amount of grease to input shaft splines. DO NOT allow grease or dirt on clutch disc or pressure plate surfaces.
Reverse removal procedure to install transaxle and engine assembly. Tighten engine mount bolts with engine weight applied on engine mounts. See appropriate TORQUE SPECIFICATIONS table at end of article. Ensure reference mark aligns on drive shaft.
Refill all hydraulic fluids to proper levels. Adjust all control cables, clutch pedal height and pedal free play. Refer to CLUTCH PEDAL HEIGHT & FREE PLAY under ADJUSTMENTS.