LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1989 >> Summit DL, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.5L 4-CYL - VIN [X] & 1.6L 4-CYL - VIN [Y] >> Removal & Installation >> Cylinder Head >> Removal (1.6L)

Removal (1.6L)

  1. To release fuel pressure, disconnect fuel pump connector. Fuel pump connector is located under rear seat cushion.
  2. With fuel pump connector disconnected, start engine and allow to idle until it stops. Turn ignition off. Disconnect negative battery terminal and reconnect fuel pump connector. Drain cooling system.
  3. Remove radiator, accelerator cable and air intake hose, breather hose, PCV hose and air cleaner assembly.
  4. Disconnect necessary coolant hoses, electrical connections, vacuum hoses and fuel lines. Remove center cover and spark plug wires. Remove wiring harness.
  5. Remove timing belt. See TIMING BELT . Remove rocker cover and semi-circular packing at rear of cover.
  6. Disconnect exhaust pipe at manifold. Disconnect tension rod at rear of intake manifold. Using Wrench (MD998051), loosen head bolts in proper sequence using 2 steps. See Fig 1. Remove cylinder head and gasket.
Fig 1: Cylinder Head Bolt Removal & Installation Sequence (1.6L)
G90H08844Courtesy of CHRYSLER MOTORS.
scientia non olet · About LEMON Manuals