Diagnostic Test

CHECK FOR AN ACTIVE DTC 

1. With the scan tool, read DTCs in all Electronic Control Units (ECUs) and record on the repair order.
2. With the scan tool, run a Vehicle Scan Report, or record the Environmental Data related to the DTCs.
3. NOTE: A front door must remain open whenever checking or erasing Radio DTCs. 
4. With the scan tool, record and erase the Radio DTCs.
5. Cycle the ignition switch from on to off, wait five seconds and then back to on.
6. Turn the Radio on and set the volume to 25.
7. With the scan tool, read the active Radio DTCs.
   NOTE:

   A front door must remain open whenever checking or erasing Radio DTCs. 

   Did the DTC return?

   Yes 

   • Replace the Rear View Camera Module in accordance with the Service Information.
   • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST or BODY VERIFICATION TEST (EV) .

   No 

   • Perform the appropriate INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .