Diagnostic Test

CHECK FOR ACTIVE DTC
1. Turn the ignition on.
2. Using the scan tool, record and erase the Radio DTCs.
3. Turn the Radio on.
4. With the scan tool, read the active DTCs.
  Does the scan tool display: B156B-19-SATELLITE RADIO ANTENNA - CIRCUIT CURRENT ABOVE THRESHOLD?
  
  Yes
  - Go To 2
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST or BODY VERIFICATION TEST (EV) .
CHECK THE ANTENNA CONNECTION
1. Turn the ignition off.
2. Disconnect the Antenna connector at the back of the Radio.
3. Inspect the Antenna connections.
  Are the Antenna connections clean and secure?
  
  Yes
  - Go To 3
  No
  - Repair the Antenna connection as needed.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST or BODY VERIFICATION TEST (EV) .

CHECK THE ANTENNA AND CABLE

Connect the test antenna (special tool #9977-6-SAT, Antenna)to the antenna connection on the back of the Radio.

GC0214825

Courtesy of CHRYSLER GROUP, LLC

Make sure one of the front doors is still open.
Using the scan tool, erase the DTCs.
Turn the ignition on.
Turn the Radio on.
Using the scan tool, read the active Radio DTCs.
NOTE:
While using the Satellite test antenna the Satellite radio reception will not be available and Satellite radio faults may occur. The Satellite test tool will only enable Satellite reception to work. For Satellite Radio reception concerns use test antenna 9977-6-SAT

Does the scan tool read: B156B-19-SATELLITE RADIO ANTENNA - CIRCUIT CURRENT ABOVE THRESHOLD as active?

Yes
- Replace the Radio in accordance with the Service information. Refer to RADIO, REMOVAL AND INSTALLATION .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST or BODY VERIFICATION TEST (EV) .
No
- Go To 4

TEST THE ANTENNA CABLE

Disconnect the Antenna cable at the base.

Connect the appropriate Adapter to the Antenna cable at the back of the Radio.

(special tool #9977-6-1, Adapter)

GC0214830

Courtesy of CHRYSLER GROUP, LLC

(special tool #9977-6-3, Adapter)

GC0214828

Courtesy of CHRYSLER GROUP, LLC

Connect the appropriate Jumper to the Antenna cable at the Antenna base.

(special tool #9977-6-4, Jumper)

GC0214827

Courtesy of CHRYSLER GROUP, LLC

(special tool #9977-6-2, Jumper)

GC0214829

Courtesy of CHRYSLER GROUP, LLC

Measure the Resistance across the tool terminals.

Is the resistance above 52.5 Ohms?

Yes

Use the (special tool #9977-6, Kit, Radio Antenna Diagnostic)to locate the open circuit, repair or replace the Antenna cable as necessary.

GC0214818

Courtesy of CHRYSLER GROUP, LLC

Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST or BODY VERIFICATION TEST (EV) .

No

Replace the Antenna base in accordance with the Service Information.
Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST or BODY VERIFICATION TEST (EV) .