LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2024 >> ProMaster 2500 Base >> Repair and Diagnosis >> Accessories & Equipment >> Entertainment Systems >> Audio (Radio) (ETM) - DTCS B1400-11 To B1496-00 >> DTC Troubleshooting >> B143A-11 Microphone 1 - Circuit Short To Ground >> Diagnostic Test

Diagnostic Test

  1. CHECK FOR AN ACTIVE DTC 
    NOTE:

    Verify the connection of the inside rearview mirror harness connector. 

    1. Ignition on, engine not running.
    2. With the scan tool, read the DTCs.

      Does the scan tool display: B143A-11-MICROPHONE 1 - CIRCUIT SHORT TO GROUND as active?

      Yes 

      • Go To  2

      No 

      • Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST or BODY VERIFICATION TEST (EV) .
  2. CHECK THE INSIDE REARVIEW MIRROR 
    1. Turn the ignition off.
    2. Disconnect the Inside Rearview Mirror harness connector.
    3. Ignition on, engine not running.
    4. Wait 10 seconds.
    5. With the scan tool, read the active DTCs.

      Does the scan tool display: B143A-11-MICROPHONE 1 - CIRCUIT SHORT TO GROUND as active?

      Yes 

      • Go To  3

      No 

  3. CHECK THE (X712) MICROPHONE 1 IN (+) CIRCUIT FOR A SHORT TO GROUND 
    1. Turn the ignition off.
    2. Disconnect the Radio harness connector.
    3. Ignition on, engine not running.
    4. Measure the resistance between ground and the (X712) Microphone 1 IN (+) circuit.

      Is there continuity between ground and the circuit being tested?

      Yes 

      No 

      • Go To  4
  4. CHECK THE (X792) MICROPHONE 1 IN (-) CIRCUIT FOR A SHORT TO GROUND 
    1. Measure the resistance between ground and the (X792) Microphone 1 IN (-) circuit.

      Is there continuity between ground and the circuit being tested?

      Yes 

      No