Oil Pump Sprocket Needle Bearing Removal
- Remove the transmission from the vehicle. Refer to REMOVAL .
- Remove the bellhousing from the transmission. Refer to BELLHOUSING, REMOVAL .
1 - Fluid Tube 2 - O-Rings - Remove the fluid tube from the bellhousing and discard the fluid tube O-rings.
1 - Filter 2 - Filter to Intermediate Support Plate Bolt - Remove the bolt holding the transmission oil filter to the bellhousing.
1 - Filter 2 - Intermediate Support Plate 3 - Filter Neck - Separate the oil filter from the intermediate support plate.
1 - Reaction Shaft 2 - Reaction Shaft Bolts 3 - Intermediate Support Plate Bolts 4 - Intermediate Support Plate - Remove the bolts holding the reaction shaft to the intermediate support plate.
1 - Intermediate Support Plate 2 - Reaction Shaft 3 - Oil Pump - Separate the reaction shaft from the intermediate support plate.
1 - Reaction Shaft 2 - Reaction Shaft Bolts 3 - Intermediate Support Plate Bolts 4 - Intermediate Support Plate - Remove the bolts holding the Intermediate Support Plate to the bellhousing.
1 - Intermediate Support Plate 2 - Oil Pump Sprocket 3 - Bellhousing - Separate the intermediate support plate from the bellhousing.
- Using a suitable screw driver, remove the input shaft seal from the bellhousing.
1 - Snap Ring 2 - Screwdriver 3 - Oil Pump Sprocket Needle Bearing - Using a screwdriver, remove the snap ring holding the oil pump sprocket needle bearing in the bellhousing.
1 - Punch 2 - Oil Pump Sprocket Needle Bearing 3 - Three Notches - Using a punch tool, remove the oil pump sprocket needle bearing by tapping outward while alternating between the three notches in the bellhousing bore.