Swivel Seat
To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Mopar® Parts Catalog. Failure to follow these instructions may result in possible serious or fatal injury.
- Move the seat to its most forward position for easiest access to the outboard seat belt retractor.
- Remove the appropriate outboard seat cushion side shield. Refer to SIDE SHIELDS, SEAT CUSHION, FRONT, REMOVAL
.
- Remove the screw (1) that secures the outboard seat belt lower anchor (2) to the seat cushion frame.
- Remove the seat back cushion and cover assembly. Refer to COVER, SEAT BACK, FRONT, REMOVAL .
- Disengage the seat belt webbing from the seat belt guide.
- Remove the screw (2) that secures the retractor (1) to the seat cushion frame.
- Remove the outboard seat belt and retractor from the vehicle as a unit.