Diagnostic Test

CHECK FOR AN ACTIVE DTC
1. With the scan tool, read ORC DTCs and record on the repair order.
2. Record the Environmental Data.
3. With the scan tool, erase DTCs.
4. Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
5. With the scan tool, read ORC DTCs.
  Did the DTC return?
  
  Yes
  - Go To 2
  No
  - Perform the RESTRAINTS SYSTEM INTERMITTENT TEST. Refer to RESTRAINTS SYSTEM INTERMITTENT TEST .
CHECK THE INSTRUMENT PANEL CLUSTER (IPC) FOR DTCS
1. Using the Scan Tool, check the IPC for DTCs.
  Are there any DTCs present?
  
  Yes
  - Repair any IPC related DTCs.
  - Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST .
  No
  - Go To 3
ACTUATE THE WARNING LAMP WITH THE SCAN TOOL
1. Using the Scan Tool, actuate the warning lamp to test its operation.
  Did the warning lamp illuminate?
  
  No
  - Repair or replace the IPC. Refer to MODULE, INSTRUMENT PANEL CLUSTER (IPC), REMOVAL .
  - Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST .
  No
  - Go To 4
CHECK THE WIRING BETWEEN THE IPC AND THE OCCUPANT RESTRAINT CONTROLLER (ORC)
1. Check the wiring on the CAN circuits between the IPC and the ORC.
  Were there any problems found on the CAN circuits between both modules?
  
  Yes
  - Repair CAN circuits for open, shorted or high resistance condition.
  No
  - Replace the ORC in accordance with Service Information. Refer to CONTROLLER, OCCUPANT RESTRAINT (ORC), REMOVAL .
  - Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST .