Diagnostic Test

DETERMINE ACTIVE OR STORED DTC
NOTE:
Make sure the battery is fully charged.
1. Turn the ignition on.
2. Perform ORC module reset. Access the Miscellaneous Function menu from the ORC ECU Overview screen on the scan tool to perform this operation.
3. Using the scan tool, read ORC DTCs.
  Is the DTC active or stored?
  
  ORC - ACTIVE DIAGNOSTIC TROUBLE CODE (DTC)
  - Go To 2
  ORC - STORED DTC
  - Perform the RESTRAINTS SYSTEM INTERMITTENT TEST. Refer to RESTRAINTS SYSTEM INTERMITTENT TEST .
CHECK FOR ADDITIONAL ACTIVE SENSOR DTCS
1. Using the scan tool, read ORC DTCs.
  Are there Impact/Pressure Sensor specific DTCs set as active in addition to the current DTC?
  
  Yes
  - Repair all other active Impact/Pressure Sensor specific DTCs before repairing the current DTC.
  No
  - Go To 3
USE THE SCAN TOOL TO IDENTIFY THE COUPLED CIRCUITS
1. Using the scan tool, identify the two or more Impact/Pressure Sensor circuits that read SET.
  Are two or more Impact/Pressure Sensor circuits DTCs set?
  
  Yes
  - Repair the two or more Impact/Pressure Sensor circuits for a Circuit Coupling condition.
  - Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST .
  No
  - Perform the RESTRAINTS SYSTEM INTERMITTENT TEST. Refer to RESTRAINTS SYSTEM INTERMITTENT TEST .