Standard Procedure - A/C Clutch Inspection
NOTE:
The A/C clutch can be serviced in the vehicle. The refrigerant system can remain fully charged during compressor clutch, pulley and bearing assembly, or coil replacement.
Examine the friction surfaces of the pulley and the clutch plate (2) for wear. The pulley and clutch plate should be replaced if there is excessive wear or scoring.
If the friction surfaces are oily, inspect the shaft and nose area of the A/C compressor (1) for refrigerant oil. If refrigerant oil is found, the compressor shaft seal is leaking and the A/C compressor must be replaced.
Check the pulley bearing for roughness or excessive leakage of grease. Replace the pulley and bearing assembly, if required.