LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2023 >> ProMaster 2500 >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating & Air Conditioning (Service Information) >> Controls >> Transducer, A/C Pressure >> Installation

Transducer, A/C Pressure: Installation

NOTE:

Replacement of the O-ring seal is required anytime an A/C pressure transducer is removed. Failure to replace the rubber O-ring seal may result in a refrigerant system leak.

GC0160206Courtesy of CHRYSLER GROUP, LLC
  1. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it onto the fitting. Use only the specified O-ring seal as it is made of special material for R-134a. Use only refrigerant oil of the type required for the A/C compressor.
  2. Install the A/C pressure transducer (2) onto the A/C line (1) and securely tighten.
  3. Connect the wire harness connector (3) to the A/C pressure transducer.
  4. Connect the negative battery cable.
scientia non olet · About LEMON Manuals